Rabbit OP7100 User Manual download pdf (Page 86)

OP710086



 Installation

Mounting

A bezel and a gasket are included with the OP7100. When properly mount-

ed in a panel, the bezel of the OP7100 is designed to meet NEMA 4 speci-

fications for water resistance.

Since the OP7100 employs an LCD display, the viewing angle must be

considered when mounting the display. Install the OP7100 at a height and

angle that makes it easy for the operator to see the screen.

Note that the contrast controls, both manual and software, act

as view-angle controls, and should be adjusted to provide

theoptimum display quality at the angle from which the display

will normally be viewed.

Bezel-Mount Installation

This section describes and illustrates how to bezel-mount the OP7100.

Follow these steps for bezel-mount installation.

1. Cut mounting holes in the mounting panel in accordance with the

recommended dimensions in Figure 6-2, then use the bezel faceplate to

mount the OP7100 onto the panel.

Figure 6-2. Recommended Cutout Dimensions

2. Remove all eight 4-40 locking hex nuts from their studs on the bezel,

and carefully “drop in” the OP7100 with the bezel and gasket attached.

4.600

(117)

7.000

(178)

3.500

(89)

5.380

(137)

.180

(4.5)

1.620

(40)

0.125 D, 8x

(3)

1.100

(28)

CUTOUT

0.150

(3.8)



1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 125 126

Comments to this Manuals

No comments

Rabbit OP7100 User Manual Page 86

Comments to this Manuals

Related products and manuals for TVs & monitors Rabbit OP7100